![]() ![]() Monosymmetry Constant (about Z and Y Axis): A measure of how symmetric a cross-section shape is about a specific axis, with a value of zero indicating perfect symmetry.Warping Constant: A value that describes a material's resistance to warping or distortional deformation.Torsion Radius: The distance from an axis at which the area of a cross-section shape must be concentrated to result in the same torsion constant as the actual shape.Torsion Constant (Using FEA): A value that describes a material's resistance to twisting or torsional deformation, calculated using Finite Element Analysis.Distance of Shear Centre to Centroid (in both Z and Y Axis): Sk圜iv centroid calculator helps calculate the distance between the shear center and the centroid of a cross-section shape.Shear Area (about Z and Y Axis): The area of a cross-section shape that is effective in resisting shear forces.Plastic Neutral Axis (about Z and Y Axis): An axis in a cross-section shape through which all forces acting on the shape must pass in order to result in plastic deformation.Plastic Section Modulus (about Z and Y Axis): A measure of the ability of a cross-section shape to resist plastic bending, used to estimate the stress of a material when it begins to yield (reach its plastic limit) under a specific load.Product of Inertia (about Z and Y Axis): A measure of a shape's resistance to rotation about a specific axis, equal to the cross product of the distance from the axis to any point on the shape and the corresponding component of the point's moment of inertia.Other Parameters – These are more advanced results calculated by the full Sk圜iv Section Builder: The Plastic Section Modulus (S) - a measurement of the ability of a cross-section shape to resist plastic bending, used to estimate the stress of a material when it begins to yield (reach its plastic limit) under a specific load and is typically used for design and analysis of beams under load.Torsion Constant (J) - also known as the polar moment of inertia or J, is a value that describes a material's resistance to twisting or torsional deformation.For instance, Szt is the section modulus about the Z axis to the top fibre of the section. They are usually calculated to the top and bottom fibres section. ![]() Zz, Zy in Britain or Australia)–Also known as statical section modulus, and are used in bending stress calculations.
0 Comments
Leave a Reply. |